產品展示PRODUCTS
When the DP-10 □ -M pressure port to connect a commercially available connector, Hold the body of the product is fixed,請避免與高壓線和動力線并行配線，或使用同一配線管日本神視SUNX壓力傳感器,CN-73-C2
更新時間：2025-02-18
訪問量：2674
廠商性質：經銷商
日本神視SUNX壓力傳感器,CN-73-C2
Tightening torque pressure port connectors when the
When the pressure port to connect a commercially
available connector, please use the 12mm wrench
The tightening torque for installation. The tightening
torque will damage the connector or commercial pressure ports.
Also, sealing tape winding is connected to the joint to prevent leakage. ,
ECO-STD reduce the brightness of the display when
compared with the conventional maximum 30% reduction in power consumption.
日本神視SUNX壓力傳感器,CN-73-C2
通過低功耗DP-100系列的電路的改進，其通常時的功耗降低了14%。
ECO-FULL時顯示屏熄滅，與通常時相比zui大降低50%的功耗
MS-DP1-7的壓力端口連接接頭時的緊固扭矩應在9.8N·m以
壓力端口連接市售接頭時，請用12mm扳手(DP-100-E型：14mm扳手)
夾住壓力端口六角部分進行 固定，并用9.8N·m以下
的緊固扭矩進行安裝。緊固扭矩過大會損壞市售接頭或壓力端口。
另外，連接時請在接頭上纏繞密封帶以防止泄漏。，
ECO-STD時降低顯示屏的亮度，與通常時相比zui大降低30%的功耗。
DP-10□-M的壓力端口連接市售接頭時，請用手握住產品本體進行固定，
并用1N·m以下的緊固扭矩進行安裝。緊固扭矩過大會損壞市售接頭或產品本體。
,CN-73-C2
銷售部